Services

Electrical work for mountain homes and businesses

Ten Mile Electric handles repairs, upgrades and new installations across Summit and Eagle counties. Residential, commercial and solar, from a dead outlet to a new service entrance. Licensed, insured, and working in these mountains since 2018.

Electrician troubleshooting a residential electrical fault

01 — Repairs

Repairs and troubleshooting

Something stopped working and you need to know why. We trace the fault to its source, explain what caused it, and repair it properly rather than resetting it and hoping. Most service calls are scheduled within one business day.

  • Breakers that trip repeatedly or will not reset
  • Dead outlets, switches and partial outages
  • Flickering or buzzing lights and fixtures
  • Appliance circuits that keep failing
  • Aluminium wiring and older mountain-home systems
Ask us about a repair
Upgraded residential electrical service panel

02 — Capacity

Panel upgrades and service changes

Older mountain properties were wired for a different era. If you are adding a charger, a hot tub or an induction range and the panel is full, the panel is the job. We size the new service, pull the permit, and label the directory so the next person can read it.

  • Service upgrades for added capacity
  • Full panel replacement and sub-panels
  • Meter bases, mast and service entrance work
  • Exterior emergency disconnects to current code
  • Circuit directories labeled and legible
Ask us about a panel upgrade
EV charger installed by Ten Mile Electric

03 — EV

EV charger installation

Tesla and universal units, sized to the vehicle and the panel that has to feed it. In condo buildings the install is rarely the hard part — board approval is. We do not file the board's paperwork, because every one of them runs to different rules, but we give you the technical detail they ask for and answer their questions directly. We also paint-match visible conduit so the finished run reads as part of the building.

  • Tesla Wall Connector and universal Level 2 chargers
  • Load calculation and panel capacity assessment
  • Coordination with your HOA board on approvals
  • Permits pulled and inspection coordinated
  • Garage, carport and exterior installations
Ask us about an EV charger
Dedicated 240V circuit installed for a hot tub

04 — Circuits

Hot tubs and 240V appliances

Anything that draws heavily needs its own circuit, correctly sized and protected. Hot tubs add outdoor conduit, a disconnect within reach of the tub, and bonding — all of which get inspected. We handle the trenching or the surface run and the connection at both ends.

  • Hot tub and spa circuits with disconnects
  • Induction ranges and 240V wall outlets
  • Water heaters, dryers and well pumps
  • Garage, workshop and snowmelt circuits
  • Conduit runs sized for exterior mountain conditions
Ask us about a 240V circuit
Residential wiring for a lighting and remodel project

05 — Remodels

Lighting and remodel wiring

Kitchens, baths, basements and additions, from a single fixture to a full rewire. We work to the drawings when there are drawings, and we work with the contractor's schedule when there is one. If a room has never had enough light, we will tell you what it actually needs.

  • Recessed cans, fixtures and under-cabinet lighting
  • Dimmers, switching and three-way circuits
  • Kitchen and bathroom remodel wiring
  • Full and partial rewires
  • Exterior, landscape and snow-season lighting
Ask us about lighting work
New construction electrical rough-in by Ten Mile Electric

06 — New builds

New construction and custom homes

From getting power to an empty lot through rough-in to final trim. Custom homes, spec builds and additions, worked to the builder's schedule rather than ours. We are usually the first electrician on a site and the last one off it.

  • Custom homes, spec builds and additions
  • Temporary power and new service entrances
  • Trenched feeders and underground runs
  • Rough-in, trim and final inspection
  • Coordination with the general contractor and other trades
Ask us about a new build
Solar combiner box and disconnects installed by Ten Mile Electric

07 — Solar

Solar wiring and interconnection

We take solar work on the larger side rather than as a routine service. Array wiring, combiner boxes, disconnects and the terminations that tie a system back into the building. Labeling is the part that gets skipped and the part an inspector opens first, so we do it properly.

  • Roof and ground-mount array wiring
  • Combiner boxes, disconnects and rapid shutdown
  • Interconnection and service coordination
  • Conduit runs sized for exterior mountain conditions
  • Labeling and documentation for inspection
Ask us about solar
Commercial electrical panel built out and labeled by Ten Mile Electric

08 — Commercial

Commercial, retail and hospitality

A large share of what we do. Retail, hotels, restaurants, tenant finish and new builds, from rough-in through to a service panel a manager can actually read at seven in the morning. We also take ongoing work for property managers and HOAs who would rather call one electrician who already knows the building.

  • Retail, hotel and restaurant electrical
  • Tenant finish and commercial buildouts
  • New commercial construction, rough-in to final
  • Service panels, distribution and equipment circuits
  • Common-area work and ongoing property management service
Ask us about commercial work

How it works

Three steps, no runaround

01

Call or send photos

Describe what is happening, or text a photo of the panel, the outlet or the charger box. We will tell you whether it is a service call or an install before anyone gets in a truck.

02

Get a quote and a date

We look at the job, price it in writing, and put you on the calendar. Estimates on installations are free. Emergencies get triaged the same day whenever we can free up a truck.

03

We do it and clean up

Permits pulled where the job needs one, work done to code, conduit paint-matched where it shows, and photographs sent to you afterwards if you are not on site.

Questions

About the work

What people ask once they know what they need.

How long does a panel upgrade take?

Most residential panel replacements are a one-day job on site, with power off for part of it. The longer part is scheduling: the permit has to be issued first and the utility has to disconnect and reconnect the service, so plan for a couple of weeks from approval to installation.

Can my panel handle an EV charger?

Sometimes yes, sometimes it needs a service upgrade first. It depends on the size of your existing service and what else is already drawing from it. We run a load calculation before quoting, so you find out before committing to a charger rather than after.

Do you install equipment I have already bought?

Yes. Plenty of customers buy the charger, fixture or hot tub themselves and need it installed correctly. Send us the model before you order if you can, so we can confirm the circuit it requires and flag anything that will not work with your existing service.

Who pulls the permit and schedules inspection?

We do, on jobs that require one. Which office issues it depends on the property, because Breckenridge, Frisco, Silverthorne, Dillon and Vail permit separately from their counties. The permit is itemised on your quote rather than buried in the labour line.

Do you work with contractors and property managers?

Regularly. We handle remodel and buildout wiring alongside general contractors, and ongoing service work for HOAs and property management companies who need one electrician who already knows their buildings. Ask about recurring work rather than call-by-call scheduling.

What if something is wrong after you leave?

You call the same number and reach the same people. We are a small crew working a defined area, which means the person who did the work is the person who comes back. That is the practical difference between a local electrician and a dispatch service.

Ten Mile Electric technician servicing a breaker panel

Get started

Tell us what you need doing

Call and describe it, or text a photo. We will tell you what it takes, what it costs, and when we can be there. Estimates on installations are free.

Call Us Today!